Many houses today have a gas fireplace, but most homeowners don’t think about maintaining them until something goes wrong, which is usually at the worst possible time. Whether you spend a few seconds to inspect some of the more obvious issues yourself or book an appointment with a reputable fireplace expert, both may save you a lot of time and aggravation in the long run.
The Not-So-Dirty Business
As you may or may not be aware, there are several types of gas fireplaces, and the requirements for maintaining each vary slightly. If a model has a standing pilot, which means the pilot light is always on, the pilot assembly is the most critical routine service item.
Some units feature a pilot light that only illuminates when the device is in use, whilst others utilize electronic ignition to ignite the burner directly without the necessity of a pilot system at all; these will require less frequent repair.
For the last several decades, all unvented gas fireplaces and gas log sets have included an Oxygen Depletion Sensor (ODS) pilot assembly to monitor safe appliance operation. This component should be cleaned once a year to prevent the system from becoming more sensitive and/or generating nuisance shutdowns.
If you are extremely handy — that is, if you can replace your own oil or the spark plugs in your car without destroying anything — you could probably do this work; but, if you are even the least bit worried about dealing with gas, it is better to leave this to a qualified expert.
The aim is to clean away the silt that has accumulated in the small pilot hole. To clear out the aperture, use a can of compressed air — those intended for keyboard cleaning would do — and the supplied straw to guide air toward it. Visit https://magikflame.com more info about gas fireplaces
NOTE: If you want to perform this yourself, make sure the pilot is turned off. If the pilot assembly is at least five years old (especially if you live near saltwater), this approach may not be as efficient as it previously was, necessitating expert intervention!
Unvented logs are meant to burn extremely cleanly; thus, if you see any sooty (black) deposits on your logs, cease using them immediately and double-check that your logs and/or burner are properly set up. If you aren’t certain that everything is in order, kindly turn off your fireplace until you can contact a professional expert to assess the problem.
Other fireplaces and gas logs require cleaning as well, albeit possibly not as regularly, depending on how frequently they are used. If there is any sooty accumulation, vented gas logs should be cleaned on a regular basis; there are commercially available sprays to aid you.
Direct vent gas fireplaces feature fixed glass panels that will need to be cleaned on a yearly basis to keep them clear. If the glass collects a black residue (soot), the fireplace should be adjusted to correct the problem. However, if the glass has a gray or white coating, there is no reason to be concerned; the residue is produced by chemical components in the gas itself (this is completely normal).
The use of ammonia-containing glass cleaners is strictly prohibited. Water and a soft cloth will typically be enough as long as this is part of your normal cleaning regimen; adding a little vinegar to the water may save you some elbow grease.
To guarantee that the task is done correctly, tougher deposits may necessitate the use of a specific fireplace glass cleaner. Before re-installing the glass, make sure it is totally dry and free of streaks and fingerprints.